6. Solar Panels


The Thin Film, Amorphous Silicon, Type of panel, is most suitable for Tropical applications


Solar Panel - Front

Solar Panels - Side
 Technical Specification
 

7. SolarMio

Your devices can be connected and charged whether the SolarMio folded or opened

Power Anytime Anywhere

Wherever you are, you will always have enough power to charge your mobile phone,GPS or iPod. The built-in lithium-polymer battery is long lasting and with 900 mAh it can charge most electronic devices once completely. The battery is easy to remove from its wallet and can therefore be used as an independent spare battery. The LEDs inform you of the charging and operating status.

Advantage of our Technology

No temperature effect Temperatures exceeding 25°C do not cause a loss in performance in our products.

Robust

Our modules are encapsulated in UV stabilized polymers, which makes them exceptionally durable

Shade tolerant

Using triple junction technology based on amorphous silicone, our products capture the broad solar spectrum. This spectrum splitting capability is the key to higher energy output.

Flexible

Exremely thin layers guarantee max. flexibility; our solar modules are 1mm thick.

Three sources

PV panel, Mains charger, Car adapter

The storage

Lithium polymer battery, chip controlled battery management

 Technical Specification
 

8. BIPV High Power Amorphous
 
Many Reasons To Recommend Kaneka Thin-Film PV !
 
Superior Performance Under High-Temperature Conditions

Crystalline-Si PV modules lose some power-generating capability with rises in temperatures. But Amorphous-Si PV modules generate higher power during summer time. Amorphous-Si PV modules can deliver maximum performance during summer when the electricity is needed most for air-conditioners in houses and offices.



 

*Kaneka Silicon PV's generated watt-power is approximately same as that of other crystalline silicon PVs during the winter months, but in summer the Kaneka Silicon PV generates significantly more power compared to other crystalline silicon PVs.
Source: "
NEDO/Ritsumeikan University Module Field Test and Operational Analysis" presented at the International PV SEC-11, Sapporo, Hokkaido, Japan, 1999.
Installation location: Kusatsu, Shiga Prefecture Japan Slope angle: 15.3 degree

*NEDO : New Energy and Industrial Technology Development Organization

Better Actual Watt-Power Generation Compared With Crystalline silicon PV Modules

Kaneka's amorphous silicon PV module (a-Si) has superior light absorption per nominal watt power. Compared with mono-crystalline silicon PV modules (c-Si) or poly-crystalline silicon PV modules (poly-Si), it generates considerably more power per nominal watt power.


 
 

Assuming that the total solar radiation per year (1.323kWh/m2) is 100%, Kaneka Silicon PV can produce 90.95% of actually generated watt-power, much higher than that of other crystalline silicon PVs (80 to 84%).
Source: "NEDO/Ritsumeikan University Module Field Test and Operational Analysis" presented at the International PV SEC-11, Sapporo, Hokkaido, Japan, 1999. Installation location: Kusatsu, Shiga Prefecture Japan Slope angle: 15.3 degree

Environmentally Friendly

The single junction a-Si layer can be made extremely thin.
The thickness of a-Si cell is 0.3 µm,which is 1/600 of that of crystalline silicon cell (approx. 200 µm).
This means that a-Si cell less material and energy thereby enabling high productivity for mass production.


 
 

Shorter Energy Pay-back Time (EPT)

EPT is the time a PV module to "pay back" the energy used in its manufacture by its own power generation.
The EPT of amorphous-Si PV is 1.6 years, which is approximately 6 months shorter than that of crystalline silicon PV (2.2 years).
EPT is one of the most important aspects when evaluating the ecological benefit of PV systems.


 
 

 

 

 

9. Controllers

Solar Voltaic, design and manufacture their own charge/controller units. Incorporated in its total function, the controller has a built in, light sensor. control circuit, for use with PV light systems, switching on automatically when surrounding darkness is sensed . This does NOT use a light sensitive resistor but uses the panels themselves to determine the outside light level.

The Solar Voltaic charge/controller has a logic control, to know when and how much to charge the battery , changing the charge voltage in relation to the temperature of the battery.

These chargers are also 100% efficient by using a by-pass system to direct 100% of the power directly into the battery, whilst merely monitoring the progress.

Another feature is the preventation, of "over charge" and also "deep discharge" , preventing damaging battery exhaustion.


SC12 CHG 10A
 Technical Specification
 

10. Oscillating Fan, Solar Powered

Maximum Air Movement from units that occupy Minimal Floor space. Internal Batteries allow you to use this Fan, without wires, in any room or even outdoors, fishing, on the Beach, Garden Party and many other uses. Additional, roof mounted, Modular, Power Pack, can give Solar power for 12 hours use per day. Wall mounted version is available.


Fan - Front


Fan - Side

 
11. Refrigerator Butane Powered

Does not require any electricity. Runs from any Butane or Propane Gas cylinder, available from most Grocery and Food stores or works from the Gas Cylinder on your existing Cooker. Lower Running costs than Electric Fridges but the same specifications and cooling


 

12. Cool Box. Solar Powered

Peltier Effect Cool Box. 5 degrees Celcius. Portable Fridge, with folding Solar Panels. Also uses the car cigarette Lighter socket, to keep cool during travel. Mains adaptor to keep cool when back at Home.


Freezer- Front


Freezer - Side


Freezer - Top


  13. Road Signs

Flashing hazard Warning signs and directional signs that light up automatically from dust to dawn alerts road users to dangers ahead
 

 

 


Next

Copyright © 2008 Solar Voltaic. All Rights Reserved. Designed by Web Channel Productions